The Pydio Cells image for VMWare is based on CentOS 7. It has been enriched with necessary third party software and pre-configured to provide an easy to run instance of the Cells server out of the box.
It is known to run in VSphere echosystems and in standalone ESXi hosts.
Download the latest VMWare image. An md5 file is also available on the same location for integrity verification.
- RAM : 4G
- CPU : 2 vCores
- CPU support: VT-x/AMD-V
- NICs: bridged adaptor
Setup a VM
In this guide, we use the simple standalone ESXi web interface to launch a new virtual machine:
- Log in your web interface
- Go to the
- Click on Create/Register VM
A creation wizard pops up.
Select creation type, choose
Deploy a virtual machine from an OVF or OVA file
- In second page, choose a name and upload both the
- Choose correct network and disk provisioning
- Click on
Finishand wait until creation is complete
- Start the virtual machine
We display the URL address of the installer when you start your VM. Check in the console that is accessed from your VirtualBox GUI.
A self-signed certificate is used by default, you have to explicitelly accept it in your browser.
Follow the steps of the wizard to finalize your setup. All parameters are set by default except the main administrator password. Upon termination, the installer saves everything, starts the
cells service and exits. It can take up to a minute to reach the end.
At this step, you can log in the app with the credentials you have just defined and verify everything is up and running.
Predefined user accounts
If you need to log into the system, the
ssh service is enabled on port
22 and following users have been created:
|sysadmin||cells||Has sudo rights without password|
|pydio||cells||Limited user that runs the app|
To connect to the default cells database in MariaDB, you have these users:
/var/cells: Pydio Cells working directory. It contains business and technical data.
/opt/pydio: binaries and additional libraries required to run Cells.
cells service is running under pydio user. The service is enabled: it will automatically restart upon reboot.
systemd commands, as
# Manually restart the service sudo systemctl restart cells # See Pydio Cells logs sudo journalctl -f -u cells -S -1h # start/stop the database (MariaDB) sudo systemctl start mariadb
Firewalld service is active and opens three ports:
- 80: cells-enterprise
- 443: cells-enterprise
- 22: ssh